供应CCB250 XP POWER\PDF 铅酸电池 12V

Output Power
Output Voltage V1
Output Current V1
Standby Supply V2 Model Number
Nominal Peak(1) Nominal Peak(1)
250 W 300 W 12.0 V 20.8 A 25.00 A 5.0 V/0.5 A CCB250PS12
250 W 300 W 15.0 V 16.7 A 20.00 A 5.0 V/0.5 A CCB250PS15
250 W 300 W 24.0 V 10.4 A 12.50 A 5.0 V/0.5 A CCB250PS24
250 W 300 W 28.0 V 8.9 A 10.70 A 5.0 V/0.5 A CCB250PS28
250 W 300 W 36.0 V 6.9 A 8.30 A 5.0 V/0.5 A CCB250PS36
250 W 300 W 48.0 V 5.2 A 6.25 A 5.0 V/0.5 A CCB250PS48

Input Voltage ? 80-275 VAC (See derating curve)
Input Frequency ? 47-63 Hz
Input Current ? 2.4 A typical at 115 VAC, full load
1.2 A typical at 230 VAC, full load
Inrush Current ? 30 A max at 230 VAC, cold start at 25 °C
Power Factor ? >0.9
Earth Leakage Current ? 250 μA max at 264 VAC/60 Hz, typically
60/110 μA, 115/230 VAC
Patient Leakage Current ? 100 μA max, 264 VAC 60 Hz
Input Protection ? Internal T5.0 A/250 V fuse in line
and neutral
Output
Output Voltage ? 12-48 VDC (see tables)
Output Voltage Trim ? ±3% (see Mechanical Details)
Initial Set Accuracy ? ±0.5% V1, ±5% V2
Minimum Load ? No minimum load required
Start Up Delay ? 1 s typical
Start Up Rise Time ? 0.5 s typical
Hold Up Time ? 16 ms min at 90 VAC
Drift ? ±0.2% after 20 min warm up
Line Regulation ? ±0.5% max
Load Regulation ? ±1% V1, ±5% V2
Over/Undershoot ? 5% max
Transient Response ? 4% max. deviation, recovery to within
1% in 500 μs for a 50-75-50% load
change
Ripple & Noise ? 1% pk-pk, 20 MHz bandwidth
Overvoltage Protection ? 115-140% Vnom, recycle input to reset
(V1 only)
Overload Protection ? 125-165% Inom V1 only
Short Circuit Protection ? Continuous trip and restart (hiccup mode)
Temperature ? 0.05%/°C
Coefficient
Remote On/Off ? Uncommitted isolated optocoupler diode,
(Inhibit/Enable) powered diode inhibits V1

General
Efficiency ? Up to 95%
Isolation ? 4000 VAC Input to Output 2 x MOPP,
1500 VAC Input to Ground 1 x MOPP,
1500 VAC Output to Ground 1 x MOPP
Switching Frequency ? PFC 30-500 kHz, Boost 25.6 kHz,
Main 51.2 kHz
Signals ? Power Fail
Inhibit, 5 V Standby
MTBF ? 369 kHrs to MIL-HDBK-217F at 25 °C, GB
Environmental
Operating Temperature ? -20 °C to +70 °C derate linearly from
+50 °C at 2.5%/?C to 50% load at +70 °C.
See derating curve & longform datasheet
Cooling ? Convection cooled
Operating Humidity ? 95% RH, non-condensing
Storage Temperature ? -40 °C to +85 °C
Operating Altitude ? 3000 m
Shock ? 30 g pk, half sine, 6 axes
Vibration ? 2 g rms, 5 Hz to 500 kHz, 3 axes
EMC & Safety
Low Voltage PSU EMC ? EN61204-3, high severity level
Emissions ? EN55011/22 level B conducted
EN55011/22 level A radiated
Harmonic Currents ? EN61000-3-2, class A
Voltage Flicker ? EN61000-3-3
Radiated Immunity ? EN61000-4-3, level 3 Perf Criteria A
EFT/Burst ? EN61000-4-4, level 3 Perf Criteria A
Surge ? EN61000-4-5, installation class 3
Perf Criteria A
Conducted Immunity ? EN61000-4-6, level 3 Perf Criteria A
Dips & Interruptions ? EN61000-4-11, 30% 10 ms, 60% 100 ms,
** 5000 ms, Perf Criteria A, B, B,
EN60601-1-2, 30% 500 ms, 60% 100 ms,
** 10 ms, ** 5000 ms, Perf Criteria
A, A, A, B - 230 VAC. Consult longform
datasheet for 115 V operation.
Safety Approvals ? IEC60950-1 CB report, UL60950-1, TUV
EN60950-1, IEC60601-1 CB report,
UL60601-1, TUV 60601-1,
Equipment Protection ? EN60601-1, ANSI/AAMI ES60601-1,
Class CSA22.2 No.60601-1 per cUL BF Rated,
Including Risk Management, EN60950,
UL60950